Reply to thread

You can pretty much use any rawhide mallet you get your hands on. The lighter it is, the more hammering you may have to do on a single hole. I have two. One is a lightweight one that I picked up from their warehouse, and the other is an interior lead weighted one, from harbour freight.

I prefer the second one, simply because it is slightly heavier. It provides a stronger drive than the lighter one.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top