Reply to thread

Message

Hey, anything to speed up the Research and development. We need to get this zam party started! By the way, Sith C is totally right. The skirt laces from the card board cut out measure 1/4" and Tandy only sells 5/32" laces. I am going to cut mine myself and have it all dyed. That way, it will be dyed on all sides of the laces.

Hey sith C, any recommendations on good tools to use for leather cutting? I looked at the back of the tandy catalog, but it seems you have to have a huge cutting table too, am I right? I mean, is there any recommendations on what you think might be better for certain cuts?

[QUOTE="Zam I Am, post: 13687, member: 165"] Hey, anything to speed up the Research and development. We need to get this zam party started! By the way, Sith C is totally right. The skirt laces from the card board cut out measure 1/4" and Tandy only sells 5/32" laces. I am going to cut mine myself and have it all dyed. That way, it will be dyed on all sides of the laces. Hey sith C, any recommendations on good tools to use for leather cutting? I looked at the back of the tandy catalog, but it seems you have to have a huge cutting table too, am I right? I mean, is there any recommendations on what you think might be better for certain cuts? [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification