Reply to thread

I was looking at photos of the screen used gauntlet hoses and also using reference from a W.I.P. build on the bounty hunters guild.


So this is what he came up with to match the screen accurate used prop.[ATTACH=full]231664[/ATTACH][ATTACH=full]231665[/ATTACH]

I found the braided hose

[ATTACH=full]231666[/ATTACH]as for the fittings I decided to kit bash things..I cut the tip off the hose [ATTACH=full]231667[/ATTACH]

Found some welder tips and cut them in half[ATTACH=full]231668[/ATTACH][ATTACH=full]231669[/ATTACH]

I ordered 1/4" male and female jacks...males will be mounted to the gauntlet and the females will be mounted inside the hose then shrink wrapped. Making the whole assembly able to unplug.[ATTACH=full]231671[/ATTACH][ATTACH=full]231670[/ATTACH]

I will post more progress tomorrow!


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top