Reply to thread

Message

build up date, while I am happy with the look I am no down with the hand painting these lines, I have to use a small brush head and it is a very slow process to begin with then I changed my mind of the colour and also I ran out of the paint I liked and couldn't find the exact same type again, so that means I would have to repaint some channels again for a third time

I have decided to just spray paint the plates and the strips separately and then glue them together, if hold seems to be an issues I'll just coat in a clear rubber spray for extra bonding

[ATTACH]67306[/ATTACH]

[ATTACH=full]67306[/ATTACH]

[QUOTE="Hussell, post: 448901, member: 9320"] build up date, while I am happy with the look I am no down with the hand painting these lines, I have to use a small brush head and it is a very slow process to begin with then I changed my mind of the colour and also I ran out of the paint I liked and couldn't find the exact same type again, so that means I would have to repaint some channels again for a third time I have decided to just spray paint the plates and the strips separately and then glue them together, if hold seems to be an issues I'll just coat in a clear rubber spray for extra bonding [ATTACH]67306.vB[/ATTACH] [ATTACH=full]67306[/ATTACH] [/QUOTE]

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification