Reply to thread

In theory, couldn't you print the WoF templates out at 50% or 75% their original size so they would be smaller?


You could just print out the pages that create the diameter of the dome first, to test and make sure it will be the right size for him, rather than printing out all the templates and it turning out to be to big/small.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top