Reply to thread

I think that for something with a rather basic shape, I'd suggest making it from cardboard, all that stuff, and moulding it using a vacuform table or something of the likes. Assuming you have access to that.


Hope I have been of help!


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top