Reply to thread

Message

Ha! That was me! That's when I switched to the fettpride V3 back plate. But like I said above, the shoulder strap of the harness should not be tight. Placement is important. The bottom of my BBF Harness sits just above my belts. And again, you really want to ensure the upper hook straps are properly adjusted. The uppers straps should have enough tension on them to hold the JP against the back plate without lifting the lower hooks off the crossbar.

[QUOTE="BooBoo Fett, post: 323071, member: 3246"] Ha! That was me! :) That's when I switched to the fettpride V3 back plate. But like I said above, the shoulder strap of the harness should not be tight. Placement is important. The bottom of my BBF Harness sits just above my belts. And again, you really want to ensure the upper hook straps are properly adjusted. The uppers straps should have enough tension on them to hold the JP against the back plate without lifting the lower hooks off the crossbar. [/QUOTE]

This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification