Reply to thread

Looking for some advice guys.


I've got a fibreglass Bobamaker back piece, and when I'm wearing my JP harness (aluminium tubing) the back plate wont meet the collar plate at the shoulder. If I had to move the collar plate up it would A. Choke me, and B. Leave a huge gap between the collar and chest pieces.


Are there any alternatives to the way the JP is carried/secured?


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top