Reply to thread

alright.  so molding pieces that are large, such as the back and butt plates can be done in sections as Boba Freekk suggested?  I had my sintra to the point of floppiness and it still got lumpy.  Should it be just pliable enough to bend (without 'forcing' it) and then cooled?


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top