Reply to thread

My BM jp is on its way:thumbsup:   I had BM reinforce the interior of my jp so I can use the HOOK system and stay movie accurate.  With the hook plates attached to the outside of the jp I should have no worries about the jp falling to the ground:confused .  I used the same system with my previous jp (RA) which was a good deal heavier than the BM jp. 

Considering the extra weight of an RA jp I did not have any problems with coming loose.  One sure way of preventing this from happing is to make the hooks a hair smaller than the "D" rings.

 ~Kevin


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top