Reply to thread

Yeah, I had problems with my hooks coming out all the time when I first rigged up this system.  Everytime I would bend over a bit or turn a specific way, the hooks would pop off the rings.  Eventually I had to move my straps up higher so there was more down tension from the JP.  I mesed around quite a bit before I got it to stay hooked all the time.  You should be able to get it to work correctly if you mess with it..  I would start by moving your attachment starps higher for starters, & see if that helps.  If that doesn't work, you can move your bottom attachment lower.  Pretty much anything that puts more tension on your hooks will most likely take care of the problem for you;)

D


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top