Reply to thread

Unfortunately I don't have any pics as I sold it for my third jet pack...........an RA fiberglass which was all done,and closed up when it came.


For filling in the gaps on the one in question I used bondo since my seam wasn't too bad.It just took mostly time and patience......oh and a couple of cans of filler primer for that glass smooth finish ;) I start all my paintable props with that stuff.


Steve


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top