Reply to thread

Hi everyone


I've been asked to build and paint a set of shin tools for the 'Dressing the Real Fett' thread

http://www.thedentedhelmet.com/showthread.php?t=23257.

Of course I was over the moon to be asked to help out with this :D. I decided to go the extra mile and make the largest tool flexible, just like the original 'Paterson' Squeegee.


I bought a 'Paterson' squeegee then sculpted the shin tool, making sure I kept the two halves separate. i then made moulds of these two pieces and made polyurethane resin copies, they turned really well. Below are the pictures showing the basic idea.


DAZ


[ATTACH=full]10492[/ATTACH]


[ATTACH=full]10493[/ATTACH]


[ATTACH=full]10494[/ATTACH]


[ATTACH=full]10495[/ATTACH]


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top