Reply to thread

Bump. any advice would be more than helpful at this point. will have piks of the helmet up soon. i cut most of the plastic that wonr be needed off, like most of the inner face mask, the block under the fin for the batteries/speaker, ect. heading down to the hardware store to pick up some lexane for the visor and (hopefully) some limmo tint to get the chrome reflective visor look.


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top