Reply to thread

Yes sir, a four-pronged punch!

 

I use a stitching groover to lightly mark a straight line (the original vinyl belt's stitches were above the surface of the vinyl, not grooved), and lightly punch the lacing holes.  The low-weight leather is too thin to use full force on either tool.  :)


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top