Reply to thread

Message

FYI, I know that MOW is or was making the Stubby pack. His work is top of the line stuff.
If I do get to the point of mas producing a pack, it will be a budget "kit".

As you will see in future postings, some the components of the pack I don't have official or unofficial dimensions for.
Like most who like to build, finding a low cost and simple way to fabricate a component is an enjoyable challenge. I'm always open to opinion on an easier, better, or lower cost way on making something.

[QUOTE="Fett Seven, post: 265061, member: 1862"] FYI, I know that MOW is or was making the Stubby pack. His work is top of the line stuff. If I do get to the point of mas producing a pack, it will be a budget "kit". As you will see in future postings, some the components of the pack I don't have official or unofficial dimensions for. Like most who like to build, finding a low cost and simple way to fabricate a component is an enjoyable challenge. I'm always open to opinion on an easier, better, or lower cost way on making something. [/QUOTE]

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification