Reply to thread

You won't find the correct studs at Tandy.  I can find them locally and a few online stores carry them.  I'm sure Cruzer can help you out better.  As for punch size, I suggest just getting a rotary punch.


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top