Reply to thread

Attempting to make my first Jango helmet. I'm a total beginner. Just got a new Dremel, etc.

would appreciate any advice to touch up the parts in the below pics. Specifically keyhole on back and the filled-in groove by the ear.


[ATTACH=full]56714[/ATTACH]


[ATTACH=full]56715[/ATTACH]


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top