Reply to thread

I've got it! The four lower blades can be operated by one slide lever that is articulated to each piece with a pin, while at the same time each blade is pivoting on a pin as its axis. The forward one would simply work in reverse. Rearmost blades; push the lever forward, foremost blade; pull its lever back.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top