Reply to thread

i would not make new chest plates from the small template but simply trace a line around the out edge about 1/4 in from the edge and just cut it.  The Small might be too small... The rest look good.  My helmet was cold cast so I did not use RnB.  But for the Jet Pack I used primer 1st than RnB.


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top