Reply to thread

Right!, second attempt i was right there was dipping in the center so I have reinforced the mould with fiberglass, and the first one is out and looking good just needs a polish and should be ready to start producing [ATTACH]39707[/ATTACH][ATTACH]39708[/ATTACH]


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top