Reply to thread

Message

Just the rest of the fans done and the helmet is complete.

[ATTACH=full]114168[/ATTACH]

[ATTACH=full]114169[/ATTACH]

I did install one fan, which was the most difficult, it's one with some LEDs attached.

[ATTACH=full]114170[/ATTACH]

[ATTACH=full]114171[/ATTACH]

Tadaaaaa!

[ATTACH=full]114172[/ATTACH]

Well, there's a little more to go, install the rest of the fans, make the crotchplate and buff up and paint the belly plate, as I said before I will probably wear a cloak for getting myself a member status, but I fully intend to backplate and jetpack in the future.

I found my old lycra baggy pants, back in the days of being stupidly overweight and I have cut them down to make a girth belt (they are red), I also cut the leg from one of my old singlets to make a collar, lycra breaths very easily, so it will cover the neck without being unduly sweaty.

All then is to get my gaunts and kneepads all sorted out and I'll start on the weapon.

Front part all sorted, now to make the crotchplate, the cloak and await for my stuff to come through the post.

[ATTACH=full]114173[/ATTACH]

[ATTACH=full]114174[/ATTACH]

[ATTACH=full]114175[/ATTACH]

<blockquote data-quote="Saz" data-source="post: 286382" data-attributes="member: 3401">Just the rest of the fans done and the helmet is complete.[ATTACH=full]114168[/ATTACH][ATTACH=full]114169[/ATTACH]I did install one fan, which was the most difficult, it&#039;s one with some LEDs attached.[ATTACH=full]114170[/ATTACH][ATTACH=full]114171[/ATTACH]Tadaaaaa![ATTACH=full]114172[/ATTACH]Well, there&#039;s a little more to go, install the rest of the fans, make the crotchplate and buff up and paint the belly plate, as I said before I will probably wear a cloak for getting myself a member status, but I fully intend to backplate and jetpack in the future.I found my old lycra baggy pants, back in the days of being stupidly overweight and I have cut them down to make a girth belt (they are red), I also cut the leg from one of my old singlets to make a collar, lycra breaths very easily, so it will cover the neck without being unduly sweaty.All then is to get my gaunts and kneepads all sorted out and I&#039;ll start on the weapon.Front part all sorted, now to make the crotchplate, the cloak and await for my stuff to come through the post.[ATTACH=full]114173[/ATTACH][ATTACH=full]114174[/ATTACH][ATTACH=full]114175[/ATTACH]</blockquote>

[QUOTE="Saz, post: 286382, member: 3401"] Just the rest of the fans done and the helmet is complete. [ATTACH=full]114168[/ATTACH] [ATTACH=full]114169[/ATTACH] I did install one fan, which was the most difficult, it's one with some LEDs attached. [ATTACH=full]114170[/ATTACH] [ATTACH=full]114171[/ATTACH] Tadaaaaa! [ATTACH=full]114172[/ATTACH] Well, there's a little more to go, install the rest of the fans, make the crotchplate and buff up and paint the belly plate, as I said before I will probably wear a cloak for getting myself a member status, but I fully intend to backplate and jetpack in the future. I found my old lycra baggy pants, back in the days of being stupidly overweight and I have cut them down to make a girth belt (they are red), I also cut the leg from one of my old singlets to make a collar, lycra breaths very easily, so it will cover the neck without being unduly sweaty. All then is to get my gaunts and kneepads all sorted out and I'll start on the weapon. Front part all sorted, now to make the crotchplate, the cloak and await for my stuff to come through the post. [ATTACH=full]114173[/ATTACH] [ATTACH=full]114174[/ATTACH] [ATTACH=full]114175[/ATTACH] [/QUOTE]

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification