Reply to thread

Your interior looks amazing so far! Your work and research have inspired me to follow a similar route.  I was able to find 3 Joe Brown helmets and all have a slightly different liner.  The closest liner to the original that i have looks just like the very first one you posted in your #1 post.

Anyways, the helmet comes with chin strapping that looks dare I say exact to the helmet strapping used in the screen used version.   When i measure the strapping I get 17.5mm in width and it fits just perfect into the cradle slots, with a very slight pinch. I took a few photos to illustrate my babbling!

[ATTACH]57407[/ATTACH][ATTACH]57408[/ATTACH]


Also, I removed the original strapping support and will be using it as a template/measuring source when I construct a more accurate strapping set-up. I can provide measurements if anyone is interested.

[ATTACH]57409[/ATTACH][ATTACH]57410[/ATTACH]


Sorry to Hi-jack your thread Andy, keep up the good work!


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top