Reply to thread

I've considered embedding some slimline magnets into the back of mine then I can fasten it to a frame and still have it removable. The magnets could even be glued to the inside of the cast rather than embedded. Once my wrist is back to full strength and I've caught up with my backlog of orders I'll tackle this and put some WIP shots here on TDH.


DAZ


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top