Reply to thread

Where does one go to learn about working with fiberglass? I mean it's not brain surgery, I'm sure with some good reference material I could learn how to work with it. You would begin with making a cast of the jet pack in question. That's another skill I'd like to master-any help there guys? Then you'd put on some kind of oil on the mold and begin putting on layers of resin and fiberglass cloth, hopefully ending with a jet pack in two pieces so you can use the mold again, with a perfectly smooth surface, no? I understand that's a generalization to say the least, but is that about right?


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top