Reply to thread

Is the stalk wide/deep enough to install a magnet into it as well?


I guess you could make a hole on the RF stalk and a hole on the opposing side in the helmet. Install a magnet on each side.. That should keep the RF up untill you carefully force the RF away. ... well granted that the magnets are off approbriate strength and distance from each other. Too far... not enough resistance... to close and they might lock to hard so that you can't seperate them without breaking the stalck. Normal refrigiator magnets should work...


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top