Reply to thread

Small correction, you have a styrene Bradley jet pack not an ABS one.  My oh my I would be so envious if anyone had an ABS jet pack. 


Bob, at least you are way ahead of me in the progess of your jet pack.  I'm still at the stage where I am epoxy-puttying the seams along the jp body.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top