Reply to thread

I'm in the process of building the PVC frame.  It was really inexpensive.  Under $12 for everything.  Plus I can tell that this will really be the "skeleton" of the structure which will allow stress to be removed from all parts of the styrene. 


Instead of using a wooden dowel, I used the remaining portion of my 5' PVC pipe.  Its 3/4" in diameter for anyone looking to get one too.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top