Reply to thread

Just a note to be careful with these...after cutting mine to size it cracked in the middle while installing.  I should have used a heat gun to soften it up (duh) before trying to install but was taken by its apparent flexibility :)


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top