Reply to thread

I'm about to buy some on Amazon and would love to hear other's experience with it.  I've come across some old threads, either here or the RPG site, but not alot was said other than to use toluene to thin it down.  Anyways, when I have my helmet sanded down and linework etched in (should have done it yesterday!), I'm going to use this stuff.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top