Reply to thread

I bought a batter's helmet from the store the other day that had a removable liner.  I placed industrial velcro inside the helmet in the pre-determined places and since the liner had peripheral flat plastic spots I applied the other side of the velcro to that.  Fully adjustable.  I had to remove a layer of the padding but after about 20 mins with a very sharp knife it fits perfectly.


I found this to be less invasive than putting more stinky adhesives in the helmet when you have to breath over several hours.


Thought I'd share. :D


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top