Reply to thread

yeah i thought it might be.  I am going to try it all on tonight just to be sure its not the mannequin making it look that way.  Then if its still too low i will cut new harness slots and raise it up a few inches


thanks guys and keep the commentary comming.  I am finally over the top and on the way down the other side of the mountain on this project.  My upgrade is nearly complete


dan


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top