Reply to thread

i am turning my 1992 cbr 600 f2 into the slave II i had a great idea for  it i just need some help making it happen i need a fiberglass molds of the slave one i just want the mold for the front end so it has to be pretty sturdy to go on the front of the bike if anyone can help me out with blueprints or molds or anything i would greatly appreciate it


[ATTACH=full]29953[/ATTACH]


This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top