Reply to thread

Message

Here's some pictures of my Hyperfirm DLT-19 conversion. I used T-track from Smitty at FISD. I made the box out of some sheet metal. I drilled some small holes in the vents to correctly wire the bottom tracks to the vents. I drilled small holes and CA glued the wire in the vent hole. Gave it a watered down wash of rust color. Then hit the silver sccents with some rub-n-buff, after wiping the majority off my finger. I followed the Braks Buddy t-track placement tutorial. The wire gauge might be a little off, but it's what I had in the garage.

[ATTACH=full]101084[/ATTACH]
[ATTACH=full]101085[/ATTACH]
[ATTACH=full]101086[/ATTACH]
[ATTACH=full]101087[/ATTACH]
[ATTACH=full]101088[/ATTACH]
[ATTACH=full]101089[/ATTACH]

[QUOTE="Jango 5204, post: 219064, member: 1082"] Here's some pictures of my Hyperfirm DLT-19 conversion. I used T-track from Smitty at FISD. I made the box out of some sheet metal. I drilled some small holes in the vents to correctly wire the bottom tracks to the vents. I drilled small holes and CA glued the wire in the vent hole. Gave it a watered down wash of rust color. Then hit the silver sccents with some rub-n-buff, after wiping the majority off my finger. I followed the Braks Buddy t-track placement tutorial. The wire gauge might be a little off, but it's what I had in the garage. [ATTACH=full]101084[/ATTACH] [ATTACH=full]101085[/ATTACH] [ATTACH=full]101086[/ATTACH] [ATTACH=full]101087[/ATTACH] [ATTACH=full]101088[/ATTACH] [ATTACH=full]101089[/ATTACH] [/QUOTE]

This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification