Reply to thread

So, say I was going to make a set of Imperial Biker Scout armor (which I am) and I am working on the chest plate and the back plate.  Just stick the whole sheet (2 by 4) in the oven and then shape it over my mold?


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top