Reply to thread

Thanks for the reply, I’m gonna end up trying it, very little at a time since I’m afraid the acetone can eat the resin


I was hoping for some kind of brush of treatment almost like the “orange” stuff.. or is it “citrus” stuff?


That stuff worked amazing for me in the past but can’t remember if I ever tried it on resin.. I know I have had good experiences with plastic model parts..


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top