Reply to thread

Ok, I am Prob. gonna have to make my own Fett Blaster. I have a friend with his own armory of weapons and I am sure I could use one of his pistols as the base of my mold. However, If I want to make the base mold(pistol grip to barrel base) of a revolver using modeling clay...How can I keep his pistol clean and still get good details? I don't want to do this if it is going to require a massive cleaning job on his pistol afterwards(not to mention he would be reluctant to allow me to cast it, he's very picky of his firearms). Any suggestions or other ways I could do this? Thanks!


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top