Reply to thread

You might be able to scuff the inside of the vinyl enough to put a layer of fiberglass inside to strengthen it. Never tried it, though. The obvious downside is you'd lose a bit of inner space on you helmet, so it'd would be even tigher.


Wayne


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top