Reply to thread

Josh - the bobamaker tutorial is in the second post. Second link.


I personally am going to use chicago screws. This way it's curved and does not have a sharp edge. Placement will vary depending on your size in comparison to the armor. Just make sure that you put enough down that it doesn't have floppy areas ;)


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top