Reply to thread

Mine sits the same way. When I was going for approval, my adviser reminded me that there should only be about 1.5 inches of the white straps showing. I had to bend my support bar a little to allow the jetpack's bottom clips to sit properly on the support bar. For positioning, I have the top of my harness sitting near the bottom of my shoulder blades. Since I am 6'4", I had to have mine sit a bit low so the support bar would be in the right position (figuring out the length of the white straps was a pain.)


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top