Reply to thread

Hey guys,

Just finished my homemade lightsaber hilt!

To make a long story short; I made it for my friend, as we're planning on going to ocean city to troop, and I told him he had to have some kind of star wars costume so I won't be embarrased to be seen with him:lol:.  Anyway, although this is hardly a whole costume, I figured it would be the start of a jedi/sith costume.

 

I used chrome-plated slip joint extensions (found in the plumbing department of your local hardware store), along w/ miscelanious other bits and THIS BASIC YOUTUBE TUTORIAL- [MEDIA=youtube]gHSVjIUml50[/MEDIA] .  this tutorial is very rough and breif, but it supplies more than enough neccesary information for forming the basic hilt design (just don't bother to whatch the goofy movie at the end):).  You'll see in the pics that I attached a tool-belt clip to the end of the gip, which isn't excatly the acurate saber-belt attachment design, but I'd figure it'd make for and easy-draw saber.

 

Now then-

I would very much like to see anyone's finished saber/saber hilt. Designs are welcome as well:p!

 

Thanks alot,



[ATTACH=full]21470[/ATTACH]


[ATTACH=full]21471[/ATTACH]


[ATTACH=full]21472[/ATTACH]


[ATTACH=full]21473[/ATTACH]


[ATTACH=full]21474[/ATTACH]


[ATTACH=full]21475[/ATTACH]


[ATTACH=full]21476[/ATTACH]


[ATTACH=full]21477[/ATTACH]


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top