Reply to thread

You might put a small slit in the back of the holster to open and accomodate the gun.  Problem is that it might end up tearing too much. 


You could make the slit and punch a small hole in the tip of either side and reinforce it with a stitching or two.  One of our garrison's more sew-friendly members might be able to help you, but I'm not naming names ;)


Phil


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top