Forums
New posts
Search forums
Non-stemming search
Media
New media
New comments
Search media
Members
Registered members
Member Map
Current visitors
New profile posts
Search profile posts
Our Communities
The Replica Prop Forum
The 405th Infantry Division
Ladies of the Legions
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Non-stemming search
Menu
Log in
Register
Install the app
Install
Forums
Star Wars Bounty Hunters • Original Trilogy
Boba Fett Helmet
Hollow BKBT stalk
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Jango Fett Jr" data-source="post: 54207" data-attributes="member: 102"><p>Success! I tried out that schematic, and it works awesome. The 100k make it too fast compared to the <a href="http://www.thedentedhelmet.com/bbt/rf_display.htm">example</a>, so I'm going to try 200k to make it half speed.</p><p></p><p>One problem I realized with my original idea in my diagram; the LEDs will need to both go to the chip, they can't simply connect together and then go to te chip with two wires. Not to fear, I will just need to change my switch a bit.</p><p></p><p>More to come!</p><p></p><p><strong>*EDIT*</strong></p><p><strong></strong>-------------</p><p>Here are some photos of my little controller board. I haven't trimmed it down yet, so it looks bigger than it is. It's really about 1.5x1.5".</p><p></p><p>Also some photos of my earpiece attached with magnets, I had to countersink them a fair bit which ended up being tricky. I modded the trianglular prism part to be a bit taller because it was too short.</p><p></p><p>[ATTACH=full]1642[/ATTACH]</p><p></p><p>[ATTACH=full]1643[/ATTACH]</p><p></p><p>[ATTACH=full]1644[/ATTACH]</p></blockquote><p></p>
[QUOTE="Jango Fett Jr, post: 54207, member: 102"] Success! I tried out that schematic, and it works awesome. The 100k make it too fast compared to the [url="http://www.thedentedhelmet.com/bbt/rf_display.htm"]example[/url], so I'm going to try 200k to make it half speed. One problem I realized with my original idea in my diagram; the LEDs will need to both go to the chip, they can't simply connect together and then go to te chip with two wires. Not to fear, I will just need to change my switch a bit. More to come! [b]*EDIT* [/b]------------- Here are some photos of my little controller board. I haven't trimmed it down yet, so it looks bigger than it is. It's really about 1.5x1.5". Also some photos of my earpiece attached with magnets, I had to countersink them a fair bit which ended up being tricky. I modded the trianglular prism part to be a bit taller because it was too short. [ATTACH=full]1642[/ATTACH] [ATTACH=full]1643[/ATTACH] [ATTACH=full]1644[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Star Wars Bounty Hunters • Original Trilogy
Boba Fett Helmet
Hollow BKBT stalk
Top