Reply to thread

I think that if you could get the templates in CAD then you shouldn't have a problem.  It looks very similar to the rock truggies.  The axels look like a mix between the mil spec Hummer axles and unimog portal axles.  A fiberglass body would be easiest.


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top