Reply to thread

Or you can try making one in metal like I did, if you have access to a welder. You can get the measurements on tk409.com and build from there. Take a look at mine by finding "Metal Bucket" in the helmet section.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top