Reply to thread

Message

I would probably patch it on inside with fibreglass, you can get fairly cheap kits off the shelf in most d.i.y stores, bit of filler maybe on the outside, sand, paint and it will be stronger than the original. Or you could use Araldite to bond it, this stuffs really strong and workable afterwards. I've used it on my body armour and its great. Pain in the ass to buy something and have to start fixing it but its not beyond repair. Good luck.

[QUOTE="B0B4F3TT, post: 512757, member: 15576"] I would probably patch it on inside with fibreglass, you can get fairly cheap kits off the shelf in most d.i.y stores, bit of filler maybe on the outside, sand, paint and it will be stronger than the original. Or you could use Araldite to bond it, this stuffs really strong and workable afterwards. I've used it on my body armour and its great. Pain in the ass to buy something and have to start fixing it but its not beyond repair. Good luck. [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification