Reply to thread

On Alex's advice, I went and bought aluminum flashing in two different gauges this evening and some snips. There's enough there for me to have several go's at trying both gauges and getting the shape right with snips and dremel, so I think I'll be good.


Thanks for the advice!

Chris


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top