Reply to thread

Well, they don't call it "styrene glue." It's usually labelled specifically for plastic models. It has the consistency of water.


The two brands I have are Ambroid Pro-Weld, and ModelMasters (Testors) Cement for Plastic Models.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top