Reply to thread

Yup, that'd sure help, Fettcicle.


Also, if by oval you mean egg-shaped, notice that there are two separate sizes of hole at the ends. Drill out these holes with the proper sized drill bits, and then file/dremel out the rest.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top