Reply to thread

Help please putting Bobo's RF light into a MLC RF


Hi


Does anyone have a tips or tricks as to how they went about putting Bobo's RF light into MLC's RF. Did you cut it open? if so what did you use to cut it with? any insight would be great as I don't want to make a mistake on this piece. Any photos of a RF with lights in use would also be nice.


Thanks in advance


Richard


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top